I have a hyper-v fail-over cluster with 4 nodes. All VM's and the hosts are on the same subnet and VLAN (601) so I've never had to worry about VLAN tagging. All 4 hosts are plugged into a layer 3 switch using trunk ports, so all VLAN's are available.
Each host has 2 physical NIC's, these are then teamed together (switch independent). Then a virtual switch (VSwitch-1) exists. 3 virtual network adapters then exist to this switch - Cluster, LiveMigration & Management.
I now have a new VM which needs to be in a particular VLAN for a door control system, this is VLAN11. The physical layer 3 switch appears to be configured ok, but I do not understated what I need to do in hyper-v and the VM itself.
Thanks in advance for suggestions, advice and help :)