Hello,
Currently, my host machine can not arp the gateway address of 10.0.1.1/24. It was able to get internet access before the hyper-v vm was configured on the 2012 R2 Server.
When the external V-switch was made the Hyper-v manager made a new interface on the server called "Data" and transferred my server ip address to this new interface. The server has the ip address of 10.0.1.11/24 and a gw of 10.0.1.1/24. After, creating the switch, the Vm was booted and installed to the disk. The Vm has a ip address 10.0.1.13/24. It was after the Vm was created that my server lost connection to the gateway. When I ran the window troubleshoot Diagnostic tool on the V-switch interface,internet access was back but lost after the arp entry expired.
I'm assuming that the troubleshoot tool block the vm machine for second that allowed my machine to arp the gateway.
My route table has a default route to the proper gateway address
The Arp table has the VM, 2012 Server, and some other statics that are in place by the machine. The gateway address is not in the arp table after about 3 mins.
I'm not sure if the correct V-switch is being used. Or if i should create a internal version and bridge it to the VM.